The Feng’s spinal (fixed-point) rotational repositioning method is the main technique for the treatment of degenerative spinal disorders. In the process of implementation, the following points should be noted: 1. The direction and degree of displacement of the spinous process should be understood before the operation, which is a prerequisite for the success of the spinal (fixed-point) rotational repositioning method. 2, the procedure should be mastered eight key points: (1) the state of spinal instability. (2) two levers, a fulcrum, that is, forward-flexed scoliosis rotation of the spine when the affected vertebral spinous process top paste reset thumb angle is just right. (3) The placement of the reset thumb can be determined according to the forward flexion, lateral bending, and rotation angle of the spine, and can be placed on the spinous process, paraspinal process, or articular eminence joint (mainly for the cervical spine). (4) The direction of thumb pivot is outward and upward. (5) The active forward flexion and lateral bending of the patient during the reset, and the active force of the upper limb of the patient holding the neck when rotating inward and backward. (6) After the spinal rotation reset posture is prepared, the reset technique is steady, accurate and light, and the combined force of the two hands is applied during the reset. (7) spinal rotation reset to one side of the rotation angle is too large, stop manipulation to the other side can be pushed to the top of the same spinous process of the upper or lower angle; two vertebral body dislocation can be pushed to the top of the other vertebral body; single vertebral body dislocation can try to top (or lower) vertebral body, but do not force, let the dislocated vertebral body to return to its own position. (8) The patient’s lumbar muscle should be relaxed during the reset, and when some patients cannot relax the lumbar muscle tension, massage or Chinese medicine fumigation can be performed before the reset to relax the lumbar muscle and prevent the lumbar muscle from causing new injury during the rotation. (9) reset process to determine the need to set the spine in the instant reset, and to hear the “click” sound We found in the clinical reset sound crisp and single, often the treatment effect is obvious, reset when there are multiple sound and sound “dull” The effect is poor, and those who do not have a “click” sound during the reset have almost no effect.