The process of making veneers can be basically divided into preoperative color comparison, preparation of abutment teeth, mold making, trial bonding and other steps, which need to be determined according to the doctor’s operation. 1. Preoperative colorimetry: Before making dental veneers, the first thing to do is to go to the hospital stomatology department to check whether the teeth are suitable for veneer restoration, after determining that the doctor will use the colorimetry board to refer to the abutment teeth as well as healthy neighboring teeth color, so as to ensure that the veneer color is natural and beautiful. 2. Prepare the abutment: After confirming the treatment plan with the patient, the doctor will use a turbine handpiece to grind about 0.2-0.8mm of the tooth body on the labial side of the tooth that needs to be restored by the veneer, and then finely polish the prepared surface of the tooth, in order to prepare for the close fit of the veneer in the later stage. 3. Modeling: After the preparation of the abutment teeth is completed, it is necessary to use silicone rubber and other materials to reproduce the model in the mouth and send it to the processing plant for production by the denture processing technician. 4. Trial bonding: veneers are produced and processed by the factory and then sent back to the hospital, where a professional doctor will try on the veneers to confirm that the veneers fit tightly and then use a special bonding agent for bonding and fixing to complete the veneer restoration. The production process of veneers needs to be determined according to the individual’s dental condition and the doctor’s operation, etc. It is recommended to be carried out under the guidance of a specialized doctor.