Before answering this question, let’s first understand “why the face after the carving line will run out”. There are 4 possible reasons: 1, the buried wire displacement buried in the level of thread sculpture is SMAS fascia superficial, and our face is an active face (there are 43 muscles of expression, there are also chewing muscles). In the process of activity, the buried wire may be displaced, it is possible to top out, but also may produce new depression, pulling and so on. 2. Too much implantation of smooth wires or insufficient needle length Too much implantation of smooth wires, the wires can’t unfold naturally in the face. When the threads are absorbed, the threads may push against the epidermis and cause localized bulging. If the needle length is not enough, the thread may also run out of the phenomenon. 3. Poor skin elasticity. The elasticity of the skin will be weakened at an older age, and the pinhole-sized wounds left behind by thread implantation may not close completely. If coupled with a large amount of implanted thread, frequent facial activities and other factors, may lead to thread drilling out of the skin. 4, did not take into account the skin into the thread 5, the operation of the tools and thread sterilization is not in place Sterilization is not in place will cause redness, itching, swelling, etc., did not get timely treatment, the infection is serious will also lead to leakage of the thread. This is unlikely to happen in a regular hospital. 6, rejection reaction 7, poor absorption The beauty seeker asked: face thread carving line run out how to do? After doing thread sculpture appear thread from the eye of the needle out of the situation, to first determine whether it is a smooth line or jagged line. Why? Because there is a difference in how smooth and jagged threads are handled. If it is a smooth line, just pull it out directly, and if it is a serrated line with the thread exposed, you must immediately go to the hospital to deal with it, because this is relatively troublesome to deal with. Usually there are two steps: 1, to pull it outward all the pull out, or as far as possible to pull out and cut 2, to carry out the key areas of disinfection and anti-infection treatment. If the candidate himself can not tell whether it is a smooth line or a jagged line, he can contact your operating doctor and go to the hospital to deal with it, which is a less risky practice.